Inverter, Pure Sine Wave, 3.5kVA, 48V | Luminous Cruze+

රු259,900.00

Sine wave output inverter with inbuilt battery charger. Output rated at 3500 VA, 2940 W. Requires four 12 V rechargeable batteries to be connected externally.

Warranty: 1-year-carry-in repair/replacement warranty for manufacturing defects. Extendable to 2-years on-site if installed by Audissey as part of a complete solution.

Available on backorder

Brand: SKU: Cruze+3.5kVA Category:

Product Overview

This inverter converts 48V DC to 220V AC. It is designed to be hardwired to the electrical panel board of a home or small office, via the 4-pole terminal block connector on the back. Four 12 volt rechargeable batteries need to be connected externally to the unit. ‘Deep-cycle’ lead-acid batteries are recommended.

As longs as input (grid) voltage remains within 180~260 Vac, the connected batteries will be charged automatically. If grid voltage falls below 180 volts or rises above 260 volts, the unit will switch automatically to inverter mode, and will use the energy stored in the batteries to provide clean sine wave power at a stable voltage to selected electrical circuits in the premises.

When grid power is restored to normal, these circuits will once again receive power directly from the grid and the unit will switch back to battery charging mode. No manual intervention is needed.

Key Features

  • 220 V pure sine wave output that is compatible with all types of electrical and electronic equipment, including those containing mains transformers and motors.
  • Rated at 3500 VA and 2940 W, which is enough to power most domestic appliances and office equipment.
  • Supports connecting four batteries (in series) for longer backup time.
  • Supports a wide range of battery types: Flat Plate, Tubular & VRLA (SMF).
  • Adaptive Battery Charging Control (ABCC) system with a maximum charging current of 21 amperes enables faster charging while protecting against over-charging.
  • Simple to operate, with an intuitive display to easily check grid power availability, battery status, etc.
  • Short-term over-load handling capability to accommodate momentary high current requirements of some appliances.
  • Two fast-acting MCBs on the back panel provide protection against short-circuits and reverse polarity battery connection.
  • Bypass switch for supplying output directly from the grid in case of a fault in the inverter.

Specifications

Inverter
Output Waveform Sine Wave
Output Voltage 220 V AC
Output Frequency 50 Hz
Rated Capacity 3.5 kVA
Battery
Battery Requirement Four 12V lead-acid batteries (not included)
Supported Battery Types Flat Plate / Tubular (selectable via switch on back)
Supported Battery Capacity 120 ~ 240 Ah
Maximum Charging Current 21 A (adjustable in 3 steps)
Connectivity
Mains Input and Output 4-pole terminal block connector
Battery Red and black captive leads with factory attached lugs (each 0.75 metres long)
General
Cooling System DC fan ×2
Audible Noise Less than 55 dBA @ 1 metre
Dimensions 305×280×380 mm (W×D×H)
Net Weight 31.9 kg

Reviews

There are no reviews yet.

Be the first to review “Inverter, Pure Sine Wave, 3.5kVA, 48V | Luminous Cruze+”